The Electromagnetic Heat Source multiphysics coupling (
) represents the source term Qe (SI unit: W/m3) in the heat equation implemented by
) represents the source term Qe (SI unit: W/m3) in the heat equation implemented by (14-6)
where J is the current density (SI unit: A/m2), and E is the electric field strength (SI unit: V/m).
The Label is the default multiphysics coupling name.
The Name is used primarily as a scope prefix for variables defined by the coupling node. Refer to such variables in expressions using the pattern <name>.<variable_name>. In order to distinguish between variables belonging to different coupling nodes or physics interfaces, the name string must be unique. Only letters, numbers, and underscores (_) are permitted in the Name field. The first character must be a letter.
When nodes are added from the context menu, you can select Manual (the default) from the Selection list to choose specific domains to define the electromagnetic heat source or select All domains as needed.
When Electromagnetic Heat Source is added as an effect of adding a Joule Heating or a Joule Heating and Thermal Expansion interface, the selection is the same as for the participating physics interfaces.
Only domains that are active in the physics interfaces selected in the Electromagnetic Heat Source section can be selected.
This section defines the physics involved in the electromagnetic heat source multiphysics coupling. By default, the applicable physics interface is selected in the Electromagnetic list to apply the Heat transfer to its physics interface to establish the coupling.
|
•
|
If it is added from the Physics ribbon (Windows users), Physics contextual toolbar (Mac and Linux users), or context menu (all users), then the first physics interface of each type in the component is selected as the default.
|
|
•
|
If it is added automatically when a multiphysics interface is selected in the Model Wizard or Add Physics window, then the two participating physics interfaces are selected.
|
You can also select None from either list to uncouple the Electromagnetic Heat Source node from a physics interface. If the physics interface is removed from the Model Builder (for example, Heat Transfer in Solids is deleted), then the Heat transfer list defaults to None as there is nothing to couple to.
 |
If a physics interface is deleted and then added to the model again, then in order to re-establish the coupling, you need to choose the physics interface again from the Heat transfer or Electromagnetic lists. This is applicable to all multiphysics coupling nodes that would normally default to the once present physics interface. See Multiphysics Modeling Approaches.
|